Picture a cap screw pulling its threads out of an aluminum housing. The screw is fine. The threads it was holding onto are sitting on the bench.
Nothing was wrong with the screw. The hole was tapped one diameter deep, the way most of us were taught, into a material about a third as strong as the screw.
When a bolted joint gives trouble, the bolt is rarely the problem. It’s the holes on either side of it: one tapped too shallow, the other drilled a size too tight. Both get sized by habit, and both are cheap to get right on the drawing and expensive to fix once the parts exist.
So we built a free tool for each hole.
How deep should the tapped hole be?
You want the bolt to break before any thread strips. A broken bolt fails at its full strength, and everyone can see it. A stripped thread fails early, and often quietly.
Pick the thread, the bolt grade, and the material you’re tapping into. The Thread Engagement Calculator works out the minimum engagement by the Machinery’s Handbook method, with worst-case thread tolerances, so the bolt stays the weak link.
That 1/4-20 Grade 5 screw in 6061-T6 aluminum? It needs 0.300 in of full thread, 1.2 diameters. One diameter wasn’t enough.
How big should the clearance hole be?
The hole on the other side gets even less thought. Drill it too tight and the parts won’t go together once real hole positions wander. Too loose and you’ve given away the alignment you were counting on.
Pick a screw and a fit. The Clearance Hole Chart gives you the hole size to put on the drawing, straight from ISO 273 or ASME B18.2.8, plus the drill that makes it for inch screws.
An M6 at normal fit takes a 6.6 mm hole. Close fit, 6.4 mm. Loose, 7 mm. Normal is the right answer unless you have a reason it isn’t.
Want 1,000 free drawings?
Every team has a family of parts it draws over and over: glands, shims, standoffs, brackets. The same few shapes at forty sizes, drawn slightly differently by whoever got there first.
We’re building Blueprints for exactly that. Set a drawing up once as a template, then get the finished sheet for every part like it with one click, inside SolidWorks or Siemens NX.
We’re giving away 1,000 free drawings to the teams that help us shape it. Anyone on SolidWorks or Siemens NX who signs up in the next two weeks, by November 4, gets a share. All we ask for is your honest feedback on what works and what doesn’t. Come get some before they’re gone.
Not sure it fits your parts? If you’re on SolidWorks or NX, sign up anyway and tell us what you draw. We read every one.
Thanks,
The Drafter team
P.S. Is there a calculator you keep rebuilding in a spreadsheet? Tell us here, and it might be the next one we build.




